Evinrude E-TEC 200, Service Manual

Page: 171 / 416

169
OILING SYSTEM
OIL CONTROL SETTINGS
8
Powerhead oil programming labels are provided
to identify
EMM oil programming. Install the cor-
rect label to alert user to specific oil requirements.
An XD100 Outboard Oil Decal, P/N 352369, is
available to label boats equipped with outboards
that have been programmed for the reduced oil
injection ratio.
Install decals in a highly visible location, such as
one of the following:
•
Dashboard/deck of boat, next to key switch
•
Deck of boat, next to the remote oil fill
•
Deck of boat, next to oil tank assembly
•
Oil tank cover
•
Cover of oil tank compartment
•
Attach to oil tank or oil fill cap.
IMPORTANT:
Make sure the engine label and
boat decals match EMM programming.
Break-In Oiling
IMPORTANT:
DO NOT add oil in the fuel tank
on Evinrude E-TEC models.
The EMM automatically supplies extra oil to the
engine as follows:
•
90° V6: First two hours above 2000 RPM
Follow these steps for outboard set-up:
Use Evinrude Diagnostics software to make sure
the break-in program has been started on a new
outboard.
•
Use the diagnostics software to start break-in
oiling after a powerhead rebuild.
The operator must monitor the oil
tank level to confirm oil consumption. This
may require several hours of operation above
idle.
CAUTION
Running an Evinrude E-TEC outboard on
other grades of oil while set to the XD100
oil ratio will result in increased engine
wear and shortened outboard life.
1. Evinrude/Johnson XD30 outboard lubricant (TC-W3)
YELLOW label
2. Evinrude/Johnson XD100 outboard lubricant (Premium)
BLUE label (Installed)
004964
XD100 Outboard Oil Decal 004522
2
1
1. Break-in oil setting 008108
1
NOTICE