Evinrude E-TEC 200, Service Manual

Page: 41 / 416

39
ROUTINE SERVICE
LUBRICATION
2
Trim and Tilt
Check reservoir fluid level every three years or
every 300 operating hours.
•
System capacity is approximately 21 fl. oz. (620
ml).
•
Tilt the outboard and engage the tilt support.
•
Remove filler cap and check fluid level.
•
Three Ram System –Add Power Trim/Tilt Fluid
or GM Dexron II , as needed, to bring level to the
bottom of the fill plug threads.
Install the filler cap and tighten to a torque of 45 to
55 in. lbs. (5 to 6 N·m).
•
Disengage tilt support.
•
Cycle the unit at least five complete cycles to
purge all air from the system. When cycling the
unit, hold the trim switch ON an additional 5 to
10 seconds after the unit reaches the end of its
travel before activating the switch in the oppo-
site direction.
CAUTION
Correct fluid level must be maintained to
ensure operation of the impact protection
built into the unit.
1. Tilt support bracket 002279
1
Three Ram System
1.
Fill cap
004277
1