Model 5600MSC Master Clock/SPG Manual
Page 2-10
Revision 1.6
INSTALLATION
ordered from the factory. Custom length weatherproof cables can also be special ordered. Alternately,
you can wire a 9 pin Extender cable as shown in Figure 2-5.
Connect the 12 pin connector on the interface cable to the smart antenna. The connector on the
interface connector has a locking ring for securing the connection.
"
CAUTION: Over tightening the locking ring can damage the connector on the smart
antenna
Route the interface cable to the location of the 5600MSC unit using the most direct path. Avoid routing
the cable near hot surfaces, sharp or abrasive surfaces, or corrosive fluids or gases. Avoid sharp kinks
or bends in the cable. Additional protection such as heat shrink tubing may be required to protect the
cable jacket at points where the cable enters the building, especially if the opening is rough or sharp.
Once the cable is run, use cable-ties to secure the cable to the pole and to provide strain relief for the
connections. When securing the cable, start at the antenna and work towards the 5600MSC unit.
Connect the 9 pin male D connector to the GPS connector on the rear panel of the 5600MSC. Power is
provided from the 5600MSC along the interface cable to the smart antenna.
Trimble antenna
Evertz 5600MSC
Mini-Con 12 pin
9 pin "D" style
(female) (male)
DC
Ground 9------------------------- 1 Frame
Ground
Receive Port (R-)
2------------------------- 2
TX A -
Transmit Port (T+)
5------------------------- 3
RX B +
Timing pulse 1pps
11 ----------------------- 4
1 PPS interrupt in +
DC Power IN
1------------------------- 5
+17 V DC Unreg.
Timing pulse 1pps
12 ----------------------- 6
1 PPS interrupt in -
Receive Port (R+)
3------------------------- 7
TX B +
Transmit Port (T-)
4------------------------- 8
RX A -
-------------- Drain
Wire
Shield
Figure 2-4: Accutime 2000 Smart Antenna to 5600MSC Interface Cable (Evertz part WA-T09)
9 pin "D" style
9 pin "D" style
(female) (male)
Pin
Pair
#
Pin
Description
7---------------- 1 ----------- 7
TX B +
2---------------- 1 ----------- 2
TX A -
8---------------- 2 ----------- 8
RX A -
3---------------- 2 ----------- 3
RX B +
4---------------- 3 ----------- 4
1 PPS +
6---------------- 3 ----------- 6
1 PPS -
5---------------- 4 ----------- 5
+17 V DC Unreg.
1---------------- 4 ----------- 1
Ground.
----------- Drain
Wire-------
Shield
Figure 2-5: Accutime 2000 Extender Cable
USO
RESTRITO
