Model 5600MSC Master Clock/SPG Manual
Page 3-40
Revision 1.6
OPERATION
Valid Genlock Types
Video
Format
Bi-Level Tri-Level
1080i/60
-----
1080i/60, 1080p/30, 1080p/30sF
1080i/59.94
NTSC-M
1080i/59.94, 1035i/59.94, 1080p/29.97, 1080p/29.97sF
1080i/50
PAL-B
1080i/50, 1080p/25, 1080p/25sF
1080p/30
-----
1080i/60, 1080p/30, 1080p/30sF
1080p/30sF
-----
1080i/60, 1080p/30, 1080p/30sF
1080p/29.97
NTSC-M
1080i/59.94, 1035i/59.94, 1080p/29.97, 1080p/29.97sF
1080p/29.97sF
NTSC-M
1080i/59.94, 1035i/59.94, 1080p/29.97, 1080p/29.97sF
1080p/25
PAL-B
1080i/50, 1080p/25, 1080p/25sF
1080p/25sF
PAL-B
1080i/50, 1080p/25, 1080p/25sF
1080p/24 ----- 1080p/24,
1080p/24sF
1080p/24sF -----
1080p/24,
1080p/24sF
1080p/23.98 -----
1080p/23.98,
1080p/23.98sF
1080p/23.98sF -----
1080p/23.98,
1080p/23.98sF
720p/60 ----- 720p/60
720p/59.94 NTSC-M
720p/59.94
720p/50
PAL-B
1080i/50, 1080p/25, 1080p/25sF
1035i/59.94
NTSC-M
1080i/59.94, 1080p/29.97, 1080p/29.97sF, 1035i/59.94
Table 3-5: Valid Genlock Types
"
Note: 720p/50 is only available when the 5600MSC is fitted with a 7751TG2-HD
Test generator Card. You can use the Firmware menu item on the GENERAL
menu to determine if your unit is fitted with the 7751TG2-HD or not.
3.6.7.3. Setting The Phase of the HD SDI Video Test Generator Output
The HD SDI black and test signal outputs will all have the same phase and can be adjusted
independent of the analog colour black and analog and SDI test signal outputs. There are two registers
that are used to set the phase of the HD SDI Test Generator output. Figure 3-9 and Figure 3-10 show
the default video sync alignment for 59.94 Hz and 50 Hz systems respectively.
"
The front panel display will show
WARNING LIVE CTL
for 0.6 seconds to indicate
that adjusting the HD SDI Test Generator output phase menu items will affect the
phasing of the HD SDI Test Generator output immediately. You do not have to
press the SELECT button to accept the new values. Use these controls with
caution, as they will affect the overall timing of devices connected to the HD SDI
Test Generator output.
OUTPUT
HD TEST GEN
HTG V Phase
HTG v phase = 1
This menu item is used to set the phase of the video output in lines.
USO
RESTRITO
