H9 User Guide
System Mode
37
When a Parameter Control Knob designator is displayed (KB0… KB9), you can map the MIDI
CC values from 0 to 127 to a selected range of parameter values. Pressing the Left Footswitch
with a KB selected will display [MINVAL]. Turn the Knob to set the minimum value. The value
is displayed while you’re turning the Knob and times out to display the selected [MINVAL]
when the Knob is idle.
Push the Left Footswitch again to set the parameter’s maximum value [MAXVAL]. Turn the
Knob to adjust the maximum value. The value is displayed while you’re turning the Knob and
times out to display the selected [MAXVAL] when the Knob is idle.
Remember, the parameters controlled in this mode are system-wide and will apply to all
Presets.
Note: While it is possible to assign more than one external controller to any parameter, doing
so is likely to cause confusion and is not recommended. Keep in mind that, if you have
previously assigned a MIDI CC to a control destination, you may want to clear the assignment
before setting up a new assignment. To clear, select the destination (parameter) and select
the source (MIDI CC) as [---].
To Setup the External Control Source
Press the Right Footswitch to select the external control source field for editing. There are two
ways to select an external control source - Manual Select or Learn Mode.
For Manual Select simply turn the Knob to choose the MIDI Control Source. The choices are:
[---] – No patch
[BND] – MIDI Pitch Bend
[C0] – [C99] - MIDI Continuous Controller messages from 0 to 99.
To use the Learn Mode to select the external control source, Press the Right Footswitch again.
“LEARN” is displayed prompting you to send a MIDI message for automatic Control Source
assignment. Press the Right Footswitch again to exit LEARN mode and revert to manual
source selection.
Press the Left and Right Footswitches to toggle between Source and Destination to make as
many assignments as you wish.
The default patch are as follows:
KB0-KB9 are patched to C22-C29. The default patch is unassigned [---] for all other [RCV.CTL]
destinations.
Press the PRESETS button once to back-up one level to MIDI menu.
Press the PRESETS button twice to go to top level System menu.
[XMT CC] – Expression Pedal/Aux Switch transmit MIDI Continuous Control
The H9’s Expression Pedal and Aux Switches can be used as MIDI controllers. Here’s how it
works: Press the HOTKNOB button to select [XMT CC]. You will see two fields (split display)
with the left side of the display showing the Control Source and the right side the
Destination. The two fields are delimited by a decimal point [PDL.C15].The Left Footswitch
LED is flashing (if it’s not, press the Left Footswitch to select this field) showing this to be the
selected field for editing.
Summary of Contents for H9
Page 1: ...H9 Harmonizer User Guide ...