H9 User Guide
The Basics
10
Using the Right Footswitch to Tap Tempo or Parameter Values
To turn Tap Mode ON/OFF, press and hold the right footswitch for 2 seconds. A blinking Tap
LED indicates that both Tap Mode and Tempo are ON. Under these conditions, tapping the
Right Footswitch will adjust the Tempo and the display will indicate the Tempo in BPM.
A solidly lit Tap LED indicates that Tap Mode is ON but Tempo is OFF. Under these conditions,
tapping the Right Footswitch will set the value of the given algorithm's "tappable" parameters.
The display will indicate the value for those parameters (usually in mSec or Hz).
To turn Tempo Mode ON/OFF, simultaneously press the Right Footswitch and the PRESETS
button.
Tip: While tapping (and with the display indicating BPM or parameter value), you can use the
Knob for fine tuning.
Tuner
Press both footswitches to enable the tuner. The LightRing indicates flat/sharp with twelve
o’clock indicating ‘in tune’. The display shows the note. Press either footswitch to exit.
H9 Power Up
When the H9 turns on it remembers what it was last doing and powers up in the same mode,
running the same Preset, with the same parameter values, same tempo, same system
settings, etc. With power off, relays connect the H9’s inputs directly to its outputs.
Can Two Presets Be Used Simultaneously?
No. When you load a Preset it runs on both channels. Presets can be used as Stereo In/Stereo
Out, Mono In/Stereo Out, or Mono In/Mono Out and Stereo In/Mono Out. The H9 is smart
enough to know what cables are connected and to automatically route the signals for your
set up.
The Routing options described later allow special purpose audio connections.
Summary of Contents for H9
Page 1: ...H9 Harmonizer User Guide ...
