H9 User Guide System Mode
30
Wet/Dry (WET.DRY,STEREO)
In wet dry mode, either one or two inputs can be used. One output will be dry, meaning that
the output is the same as the input (or mix if two inputs are used), whereas the other will be
wet, using a mono output version of the effect. If only one input is used, this should be Input
1.
The wet connection can be selected on a preset by preset basis. This means that either output
1 will be wet, or output 2. A normal stereo output can also be selected.
. When in Wet/Dry mode, you can pick from the above options:
Press and hold the Left Footswitch as described elsewhere. The display will show the
Output Level.
Press the Encoder until the display shows WET1 (default), WET2 or STEREO.
Turn the Encoder to set it as desired.
Release the Footswitch - the Preset will return to its previous Active or Bypassed
state.
Remember to save the preset, or the change will be lost.
WET1 – Physical Output 1 will be wet, Output 2 will be dry. When Bypassed, if KillDry is set,
Output 1 will be muted, while Output 2 will always be dry.
WET2 - Physical Output 2 will be wet, Output 1 will be dry. When Bypassed, if KillDry is set,
Output 2 will be muted, while Output 1 will always be dry.
STEREO – this is the normal operating mode where both channels are Wet unless bypassed. It
is here to allow you to return to normal stereo mode on a preset by preset basis. For example,
in a two amplifier setup, you might want a shifter to come from one amp, but a reverb to
feed both.
In WET/DRY mode, Input and Output Swell only affect the Wet channel.
Summary of Contents for H9
Page 1: ...H9 Harmonizer User Guide ...
