H9 User Guide
System Mode
34
To Setup Control Destinations
Turn the Knob to select an external control destination. Destinations include the H9
parameters and functions that can be controlled by one of the Aux Switches. The choices are:
[BYP]
Toggle Bypass/Active. Bypass type selected in BYPASS)
[PR+]
Increment Preset number without loading the preset
[PR-]
Decrement Preset number without loading the preset
[NXT]
Load the next preset
[LST]
Load the previous preset
[TAP]
Tap tempo switch function.
[PSW]
Toggle or enable the Performance Switch function
[KB0]…[KB9] - Parameter Control Knobs
[TUN] – Enable tuner
The following Looper functions only work with the Looper algorithm
[REC]
Record
[PLY]
Play
[STP]
Stop Play or Record
[MT]
Empty (erase any current recording)
[DIR]
Change Play direction
[OCT]
Change Play speed up or down by an octave
Performance Switch [PSW] – The Performance Switch is used for ‘infinite repeat’ with
TimeFactor algorithms, ‘rate change’ with ModFactor algorithms, various functions with
PitchFactor algorithms and ‘HotSwitch’ with Space algorithms. Refer to the specific algorithm
description in the Algorithm Guide for details.
Parameter “Knobs” [KB0]-[KB9] - You can use the Aux Switches to control up to 10 virtual
“Knobs.” KB0-KB9 correspond to the ten parameters of the currently running algorithm. For
example, if a Preset based on the Dual Delay algorithm is currently running, KB0 corresponds
to the “MIX” parameter. If the H9 is running a Preset based on the Rotary algorithm, KB0
corresponds to the “INTENSITY” parameter.
When driving KB0-9 from the Aux Switch, each press of the switch normally toggles between
one of two values. As an alternative, there are three
momentary
sources, [TI.P.], [RN.G.] an
[T+.R.]. These will give one value when pressed and another when released.
After you’ve selected a Parameter Control Knob, you can set two values for the parameter; a
minimum value [MINVAL] and a maximum value [MAXVAL]. Each time the assigned switch is
pressed, the parameter value instantly toggles between the minimum and maximum value.
When a Parameter Control Knob designator is displayed (KB0… KB9), pressing the Left
Footswitch will display [MINVAL]. Turn the Knob to set the minimum value. The value is
displayed while you’re turning the Knob and times out to display the selected [MINVAL] when
the Knob is idle.
Push the Left Footswitch again to set the parameter’s maximum value [MAXVAL]. Turn the
Knob to adjust the maximum value. The value is displayed while you’re turning the Knob and
times out to display the selected [MAXVAL] when the Knob is idle.
The parameters controlled in this mode are system-wide and will apply to all Presets. For
example, you could assign an Aux Switch to Decay (KB1) with [MIN VAL] set to 1 sec and
[MAX VAL] set to 2 sec. Pressing the switch will toggle between these two decay values. If
another Effect or Preset is chosen, the Aux Switch will affect the parameter controlled by KB1
for the currently loaded effect.
Summary of Contents for H9
Page 1: ...H9 Harmonizer User Guide ...