Eclipse User Manual
Release 4.0.1
Page 27 of 66
Eclipse User Manual
By changing
SETUP
DIG-OUT
FORMAT
(EMPHASIS)
from
off
to
on
, you can add emphasis flags to your
output audio. If you’ve never heard of “emphasis,” leave it
off
and skip the rest of this paragraph!
Emphasis is an outmoded “feature” of older A/D and D/A technology that filters the digital audio to make the best use of
available headroom. However, few devices use emphasis these days, so you probably want to leave it off unless you have good
reason to do otherwise. Changing the emphasis flag does NOTHING to the actual audio, it just turns the flag on and off (so, in
this sense, your Eclipse can misinform). Setting the emphasis to
thru
simply mirrors the output flag so that it matches the input
flag.
Assuming that you’ve set (
CS-TYPE)
to
Cns
, you can select copy status
at
SETUP
DIG-OUT FORMAT (SCMS)
. Your choices are:
copy OK
This will allow subsequent digital devices to make unlimited copies of the output audio.
You should leave it set to
copy OK
unless you feel justified in doing otherwise…
1 more
This will allow only one subsequent digital device to use the output audio. After that, no
more digital copies are permitted.
no copy
This will allow
no
subsequent digital devices to use the output audio. …a good way to pro-
tect your wares from flea-bitten pirate varmints!
Select
SETUP
DIG-OUT FORMAT (BITS)
to choose the output word
length:
24
,
20
, or
16
bits.
ADAT Output or Two-Channel Optical Output?
The optical output can be made to send eight-channel digital audio in the
ADAT protocol (
ADAT
) or two-channel digital audio in the protocol cho-
sen above (
S/PDIF
).
Select between the two at
SETUP
DIG-OUT (OPTICAL)
. (You should not select
ADAT
for sampling rates
above 50kHz.)
If you select
ADAT
, proceed to
SETUP
DIG-OUT
(ADAT-OUT)
. Repeat-
edly press
ADAT-OUT
to select each channel in turn and use the knob to
change the status of its output. Your choices are:
Thru
The selected ADAT channel will carry the same signal that the corresponding ADAT input
carried.
Mute
The selected ADAT channel will carry silence.
Ch 1
The selected ADAT channel will carry the Eclipse’s channel 1 output.
Ch 2
The selected ADAT channel will carry the Eclipse’s channel 2 output.
If you select
ADAT
for the optical output, the other digital outputs send
the format selected at
SETUP
DIG-OUT FORMAT (CS-TYPE)
as de-
scribed above.
Summary of Contents for Eclipse
Page 2: ...This page is intentionally left blank ...
Page 64: ......
