EVA MAJOLICA LINE, Instruction Manual

Page: 43 / 90

42
10. MICRONOVA ELECTRONICS WITH LCD DISPLAY
10.3.4 Working mode
At the end of the start-up phase, if no problems occurred, the stove enters its normal working mode.
Exchangers are enabled if the fume temperature is higher than Pr15. Exchangers no.2 and 3 start working only if they were previously
enabled.
fig. 18
10.3.5 Changing set room temperature
Press P1 and P2 buttons to change the room temperatture. The display shows the current SET temperature value
as in
figure 19
.
fig. 19
10.3.6 External thermostat/programmable thermostat
If you want to use an external programmable thermostat, connect it to the TERM clamps (connector CN7 pin 7-8).
•
external thermostat : set the stove SET temperature to 7°C.
•
external programmable thermostat : set the stove SET temperature to 7°C and disable the chrono functions from 03-01
menu.
The stove external thermostat is enabled when the contact is closed with stove on.
10.3.7 Room temperature reaches set value (SET temperature)
When the set room temperature value is reached or the fume temperature has reached the Pr13 value, the stove heat output is set
automatically to the minimum value (MODULATION mode). See
figure 20
fig. 20
If the stove is in the STAND-BY mode, it switches off after the period of time set by Pr44 and after reaching the SET temperature. If
the following condition occurs - Tambiente > (TSET + Pr43), it is then possible to switch the stove back on.
room temperature time clock
dialogue
heat output
set value
dialogue
room temperature time clock
dialogue heat output