-10-
GB
6. DESCRIPTION OF THE SCREEN AND MENUS
ACTIONS POSSIBLE FROM THE WELCOME SCREEN
By default, the screen goes into standby
mode after 30 seconds of inactivity.
To exit standby mode, touch the surface of
the screen.
3cl
6cl
12cl
6°C
18°C
To lock / unlock
You will be asked for your “manager” or “waiter”
password.
•
The key picture is red:
•
Vin au Verre 8.0 is locked, the taps are closed
– no drinks can be served
•
• The key picture is green: the Vin au Verre
8.0 is in operation
To switch the lights on/off for the entire product
(taps and compartments)
Shortcut to
Daily cleaning menu. This indicator
light will flash to remind you to carry out cleaning
Shortcut to
Bottle changing menu for a bottle of
the same label
Access to
Settings menu.
You will be asked for the “manager access”
password
Other information
•
The indicator light will flash to tell you to
check the nitrogen level
•
To obtain the instructions, send an email to
the address shown on this menu. A link will
be sent to you so that you can obtain the
instructions in electronic format
6°C/18°C
°C: Displays the temperature setting in both
compartments.
Can also be set in Fahrenheit
Displays the level of wine remaining in each
bottle in real time
Displays the measure if all set measures are
identical for all 8 bottles.
If the 8 bottles all have different settings, the
measures will be shown below each of the
bottles (the smallest measure at the top, the
largest measure at the bottom)
The glass holders allow you to serve several glasses at the same time
(up to four glasses).
2 glass holders are supplied with the product: 1 per door. Fitting of the
glass holders is optional.
The glass holders are made up of 2 sections:
- A metal section, to be fastened to the product,
- A transparent section, to be fitted inside the metal section
To install the metal section of the glass holder:
•
Using a 4mm Allen key (supplied), slightly unscrew (only
perform one rotation) the 2 screws located at the top of each
door without actually removing them (2)
•
Slot the metal section of the glass holder into the recess (3)
•
Tighten the 2 screws (4)
To fasten the transparent section:
Simply install the outside section of the door (2) first,
then inside (3) (see diagram below) and lower
It is possible to choose the height of the transparent section according
to the type of glasses used.
Position your glasses as close as possible to the tap in order to
optimise the quality of the wine served.
1
6 ° C
16 ° C
3cl
6cl
15cl
3
x1
2
4
4
4
x1
6 ° C
16 ° C
3cl
6cl
15cl
2
6 ° C
16 ° C
3cl
6cl
15cl
1
3
4
5
5. INSTALLING THE GLASS HOLDER
Summary of Contents for Vin au Verre 8.0
Page 23: ......
