Euroboor B60, Operator'S Manual

Page: 22 / 48

22
3.5 Setting bevel angle
EUROBOOR B60(S) provides stepless bevel angle adjustment, with a range from om 0 to 60 degrees.
To set the required bevel angle:
1. Loosen both angle adjustment lock bolts with supplied 6 mm Allen key. One can be found at
either side of the milling head cover. It is not necessary to loosen the bolts completely.
2. Rotate the guide plate assembly in such a way, that the indicator stripe on the guide plate
assembly lines up with the desired amount of degrees
3. Tighten both angle adjustment lock bolts a little bit, double check if the angle adjustment is
still set to the desired amount of degrees, and tighten the bolts completely. Be careful not to
overtighten the bolts.
[image 2-5]
Note: set the bevel angle before setting the bevel depth!