Euroalpi Pasubio, Use And Maintenance Manual

Page: 30 / 45

30
12. ALARMS
In the event that a malfunction occurs, the board intervenes and signals the irregularity, lighting the LED
Alarm (Alarm LED on) and producing acoustic signals.
There are the following alarms:
Alarm origin Display view
Energetic Black-out AL 1 BLAC-OUT
Probe temperature smokes AL 2 PROBE EXHAUST
Fumes overheating AL 3 HOT EXHAUST
Encoder fumes failure AL 4 FAN FAILURE
Firing failure AL 5 NO LIGHTIN-
Pellet absence AL 6 NO PELLET
Overheating thermal safety AL 7 SAFETY THERMAL
No depression AL 8 FAILURE DEPRESS
Each alarm condition causes the immediate turning off of the stove
The alarm state is reached after the time PR11, EXCEPT THE ALARM OF BLAC-OUT, and can be reset by
pressing and holding the button P4. Whenever an alarm is reset, a turning off phase of the stove is
initiated for safety. During the alarm phase the alarms LED will always be on (Alarm LED on) and when
enabled the buzzer, it will sound intermittently. If you don’t reset the alarm, the stove will shut down
anyway, always displaying the alarm message.
12.1 Energetic Black out
During the working status of the stove, electricity may miss. When it is restarted, if the period of the black-
out is lower than the parameter PR48, the stove restarts on WORK mode, otherwise the alarm is activated.
The message "Al 1 BLAC-OUT " will pass on the display (
Figure 20
) and the stove goes off.
Figure 20
12.2 Probe smokes temperature alarm
It occurs in the case where the smokes probe is damaged. The stove goes into alarm, the alarms LED
lights up (Alarm LED on). The stove will show, "Al 2 PROBE EXHAUST " on the display (
Figure 21
) and will
turn off. In this case, reset the alarm by pressing the On / Off button and contact your authorized service
center.
Figure 21
Al1
BLAC
OUT
Al2
PROBE
EXHAUST