5
Pumping up sports equipment (e.g. basket balls)
or balloons
1. Undo the 12 Volt cable.
2. Screw the ball/balloon adapter to the threaded
connector at the hose end.
3. Insert the ball/balloon adapter into the valve of the
object you wish to pump up.
4. Start the compressor by connecting the 12 Volt
adapter with the 12 Volt connection of your vehicle.
Wait until the desired fi rmness has been achieved
or the object is completely pumped up.
5. Remove the adapter from the valve of the pumped
up object and unscrew to the remove the threaded
connector at the hose end.
6. To switch off the compressor, separate the link with
the 12 Volt connection.
NOTES REGARDING ENVIRONMENTAL
PROTECTION
CONTACT INFORMATION
TECHNICAL DATA
• Operational voltage: 12 Volt
• Maximum pressure: 17 bar / 250 PSI
• Power supply: 12 Volt
• Size (L x W x H): Approximately 15 x 6.5 x 13 cm
• Weight: Approximately 620 g
• Accessories: 3 adapters
CAREFUL
Do not generate overpressure,
this may lead to injury or des-
truction of the device. Do not
leave the compressor unattended
when in use! Allow the compressor
30 minutes to cool down for every
10 minutes of constant operation.
NOTE
NOTE
Check the tyre pressure of your
vehicle using the recommended values
in the operating instructions to avoid
over pressure. Bicycle tyres should be
checked using the tyre designation.
During pumping the manometer only
off ers an estimated value. A precise
pressure value cannot be read off .
The packaging is made up of
environmentally friendly materials
which may be disposed of via your local
recycling points.
Do not put electrical devices into
the household waste. Electro-
nic and electrical devices must be
collected separately and sent for
environmentally friendly recycling.
Contact your community or town
administration for information
regarding the disposal of electrics.
EAL GmbH
Otto-Hausmann-Ring 107
42115 Wuppertal, Germany
+49 (0)202 42 92 83 0
+49 (0) 202 42 92 83 – 160
[email protected]
www.eal-vertrieb.com
Summary of Contents for 21066
Page 12: ...12 12...
