97
11-5 Crankshaft Inspection
Use a thickness gauge to measure left and right
clearance of connecting rod big end.
Service limit: 0.6 mm
Measure the clearance of the big end at the
vertical directions.
Service limit: 0.05 mm
Place the crankshaft on a V-block, measure
run-out of the crankshaft.
Service limit: 0.10 mm
Check crankshaft bearing
Use hand to crank the bearing to see it moves
freely, smoothly and noiseless.
Check the inner ring to see it links firmly on the
bearing.
If any roughness, noise and loose linkage are
detected, replace the bearing with new one.
Caution
The bearing shall be replaced in pair.
Special tool: outer bearing puller
Check balance shaft bearing
90 mm
Crank bearing
Measure point for the crank
big end of the connecting rod.
60 mm
Summary of Contents for VECTOR 250 - SERVICE
Page 114: ...114 Handle bar...
Page 128: ...128 REAR BRAKE...
Page 149: ...149...
Page 150: ...150 12 8 WIRING DIAGRAM...
