ETAS ES5340.2, User Manual

Page: 20 / 120

ES5340.2 Electric Drive Simulation Board - User’s Guide 20
Introduction ETAS
1.8 About This Manual
This manual consists of the following chapters:
• "Introduction" on page 7
This chapter
• "Installation and Configuration" on page 23
• "Hardware Description" on page 31
• "FPGA Models" on page 49
• "Configuring the Hardware in LABCAR-RTC" on page 65
• "Connector Assignment and Display Elements" on page 97
• "Order Information and Scope of Delivery" on page 103
• "Technical Data and Standards" on page 111
• "ETAS Contact Addresses" on page 115
1.8.1 Using This Manual
Representation of Information
All activities to be carried out by the user are shown in what we call a "Use-
Case" format, i.e. the target to be achieved is defined briefly in the title and the
individual steps necessary to achieve this target are then listed. The information
is displayed as follows:
Target definition
Any introductory information...
1. Step 1
Possibly an explanation of step 1...
2. Step 2
Possibly an explanation of step 2...
Any concluding remarks...
Concrete example:
To create a new file
If you want to create a new file, no other file may be open.
1. Select File
→
New .
The "Create file" dialog box appears.
2. Enter a name for the file in the "File name" field.
The file name must not exceed 8 characters.
3. Click OK .
The new file is created and saved under the name specified. You can now work
with the file.