eSync DVR Manual
Revision A
- 39 -
© 2008 eSync Manual
© eSync
System
Setup
4) Alarm
Out
-
This feature is allows to generate alarms through the buzzer, email notification, spot monitor, or
relay in case of an alarm event.
1) Buzzer - This feature is used to run the internal buzzer in the DVR in case of an event.
1.
Select
{Alarm Out}
{Buzzer}
for the channel using the arrow keys and press the [Select] button.
2. On the selection window, select the event subject to buzzer operation (e.g., motion, sensor, sound)
using the arrow keys and press the [Select] button to activate or deactivate the buzzer.
2) Preset - When an event occurs, the PTZ camera will move to an assigned preset.
1.
Select
{Alarm Out}
{Preset}
for the channel using the arrow keys and press the [Select] button.
2. On the selection window, select the event (sensor or sound) to activate an alarm or not by using the
arrow keys and press the [Select] button.
3.
Select
{Alarm Out}
{Preset}
{Preset Action}
for the channel using the arrow keys and press the
Menu button.
4. Assign a Preset for each event.
5. Select the OK button to save. Otherwise, select the cancel button and press the [SELECT] button to
cancel.
[Figure 5-4. Preset Action Setting Window]
To set all channels at the same time, navigate the arrow keys to go to the top of the
{Preset}
column
and
press the [Select] button.
Preset can be set from 1-8
3) Email notification - When an alarm or an event occurs, emails will be sent to the specified email address.
1. Select
{Alarm Out}
{Mail}
for the channel using the arrow keys and press the [Select] button.
2. On the selection window, select event types to activate the email notification by usng the arrow keys
and press the [Select] button.
The email notification can be set up in the
{Application Setup}
{Network}
{Alarm}
menu.
4) Spot - Displays the video on the TV monitor connected to the spot out on the rear side of the DVR during an
alarm
event.
1. Select
{Alarm Out}
{Spot}
for the channel using the arrow keys and press the [Select] button.
2. On the selection window, select the event type to activate the spot function by using the arrow keys and
press the [Select] button.
To set all channels at the same time, navigate the arrow keys to go to the top of the
{Spot}
column and
press the [Select] button.
Summary of Contents for SSA-0424e
Page 1: ......
