www.esylux.com
9 13
/
PRESENCE DETECTOR PD-C360i/24 KNX ECO (EP10425844)
GB
10.1 • LIGHT CHANNEL OPERATING MODE
•
“Half automatic”
operating mode
If “Half automatic” mode has been selected, the lighting must be
switched on manually using infrared remote control (Mobil-PDi/User)
or by telegrams, e.g. by pressing external KNX/EIB buttons.
This means that the detector does not automatically switch ON the
lighting when persons are present.
If the artificial light has been switched on manually despite high ambient
brightness conditions (ambient lighting level is higher than the preset light
value), the lighting will remain switched on for as long as the detector
continues to detect movement (light measurement is disabled). If no more
movement is detected, the lighting is switched off after the set switch-off
delay time has elapsed.
The lighting can subsequently be switched back on manually at any time.
If the artificial light has been switched on manually due to low ambient
brightness conditions (ambient lighting level is below the preset light
value), the lighting will remain switched on for as long as the detector
continues to detect movement (light measurement is enabled). If no more
movement is detected, the lighting is switched off after the set switch-off
delay time has elapsed.
However, should the natural lighting level increase and the ambient
lighting level exceed the preset light value, the detector will automatically
switch the lighting off 5 min. after reaching the preset light value,
regardless of any presence.
The lighting can subsequently be switched back on manually at any time.
NOTE: External ON telegram, e.g. through KNX/EIB button, is essential in
“Half automatic” mode.
NOTE: Applies to switching and constant light control features.
Default setting: Full automatic
