Mobil-PDi/MDi remote control
Doc. no. MA007828_00
27 / 34
EN
But-
ton
Simple programming mode for
programs 1-4
Enhanced programming mode for
program 5
Channel 2 switch-off delay time
15 min./
min. detector sensitivity/
min. microphone sensitivity
Channel 2 switch-off delay time
15 min.
Channel 2 switch-off delay time
30 min./
Activate detector sensi-
tivity setting
(see section 7.3.5)
Channel 2 switch-off delay time
30 min.
Channel 2 switch-off delay time
60 min./
Activate microphone
sensitivity
(see section 7.3.6)
Channel 2 switch-off delay time
60 min.
LED On/Off
–
12 hr operation on/off
–
7.3.2 Setting program 5
To adjust these settings, you first need to activate program 5 using the
touch panel (see above section “5.1 Switching on and off and selecting a
program”).
To set program 5 according to your requirements:
Prerequisite:
• Program 5 is active.
1. Press the
button twice to activate advanced programming mode.
The light blue LED is lit.
2. Set the switch-off delay time, switching value and other parameters
using the buttons (see table in section 7.3.1).
3. Press the
button twice to exit advanced programming mode.
Program 5 is configured according to requirements.
The settings remain stored after power cuts and after a factory
reset.
7.3.3 Setting programs 1 to 4
If one of the programs 1 to 4 largely corresponds to your requirements, you
can adjust these programs by changing individual settings.
To make the settings, the required program must first be activated using
