Reset programs
Doc. no. MA007828_00
17 / 34
EN
current program.
Example: If the dark blue LED flashes 3 times, the detector is
currently in program 3.
3. Use further short touches change the program until you reach the
program you require.
4. Use a long touch to save the program selection and exit Program
selection mode.
The detector is set to the required programming mode.
In program selection mode, the program number is increased from
program 1 to 5 with each short touch. After program 5 is reached,
the count begins again at program 1.
The detector exits program selection mode automatically after 10
seconds if the touch panel is not touched.
6
Reset programs
The detector has five programs. Four of these contain settings for different
applications. The fifth program can be programmed to your own settings via
remote control.
The four programs have different settings for the following parameters:
• Length of switch-off delay time
• Switching threshold: The detector switches on as soon as the ambient
light drops below the set value and presence is detected. The detec-
tor switches off when the brightness reaches or exceeds the set Lux
value.
• Automatic mode:
In fully automatic mode, the lighting switches on automatically when
the detector detects a presence.
In semi-automatic mode, the detector has to be activated manually
for the presence detection to begin.
Automatic mode can be set using the remote control Mobil-PDi/MDi
(see section 7).
• Locked touch commands: Don’t want the user to be able to switch
the lighting off manually? In program 3, the detector can only be
switched on by short touch command.
The microphone is deactivated in all programs. It can be activated by re-
mote control (see section 7.3.6).
Fully automatic
-
Semi-automatic
