Estate Swing E-SC 400, Instruction Manual

Page: 15 / 37

E-SC 400 / 402 Classic Series Instruction Manual
2.4
Installation of Operator
5) Find your horizontal position on the column for your motor
bracket. The motor bracket should be centered at the end of
the B measurement. Using a carpenters pencil, make a vertical
mark on the two sides of the bracket.
6) Find your vertical position of the column for your motor
bracket. Identify the horizontal bar on the gate you are go-
ing to attach the motor arm to. The top of the horizontal bar
on the gate being used for mounting should be level with
the bottom of the motor bracket.
TIP: Take a level and rest one end of the level
on the top of the lip of the bottom of the bracket.
Place the other end of the level resting on the top of
the gate’s horizontal bracket.
7) Place the bracket in the final position that is matched up
horizontally and vertically to the above two steps. If pur-
chasing your own anchor bolt, drill the holes using a 1/2
inch masonry bit. If using the provided anchor bolts, drill
the holes using a 15 mm masonry bit.
8) Using the provided long bolts, attach the rear of the motor to the
bracket.