Estate Swing E-SC 400, Instruction Manual

Page: 8 / 37

E-SC 400 / 402 Classic Series Instruction Manual
Standard System Overview and Safety Zone
The system displayed below is a recommended standard system. Other approved accessories can be installed.
Photo sensors and a flashing light indicating gate movement is recommended for safety purposes.
1,2 Estate Swing Operator
3 Photocells (not included)
4 Control Board
5 N/A
6 Push Button Opening Device (not included)
7 Receiver extension (not included)
8 24V DC Flashing Lamp (not included)
9 Positive Stop (not included)
10 AC Transformer
Notes: 1) When laying electrical cables, use appropriate rigid and/or flexible tube.
2) Do not run any wires in the same conduit as 110 AC power that may be in the area. This will cause
danger of electrocution.
Important: Preliminary Checks:
To ensure safety and an efficiently operating automated system, make sure the following conditions are ob-
served.
The gate and post must be suitable for being automated. Check that the structure is sufficiently strong and
rigid, and its dimensions and weights conform to those indicated on page 1.
Make sure the gates move smoothly without any irregular friction during entire travel.
Make sure the hinges are in good condition. Ball bearing hinges are ideal for gates weighing over 200 lbs. or
over 10’ in length.
Make sure the gate is plumb and level.
The fence post must be secured in the ground with concrete. is will prevent alteration of alignments and level-
ing during installation and during cycles.
1.3