Essex Electronics, Inc. | 805.684.7601 | 800.KEY-LESS | fax 805.684.0232 | keyless.com
8
1. Select a flat surface (1 ¾” by 7”) near the door where you wish to
install the keypad.
2. Using the Thinline template, mark location of holes.
3. Drill the large hole using a 1” (25mm) drill bit.
4. Place the connector on the back of the keypad in the large hole
to verify that the mounting holes are aligned. Make adjustments
if necessary.
5. Drill mounting holes in accordance with fastening method used.
If mounting to wood, drill small pilot holes and use #6 flat head
wood screws provided. If mounting to metal, drill two 5/32”
clearance holes for #6 flat head machine screws provided.
6. Do NOT mount the keypad at this time.
7. Proceed to Install the Wiring Cable.
Install the Wiring Cable
1. Drill a ½” hole in the inside wall or ceiling where you want the
cable to come through.
2. Pull the cable through the hole so the connector end goes to the
keypad. Route it so there is minimal cable at the keypad.
Note: Supplied with the system is a 12-conductor cable designed
to connect the keypad to the control module. You will also need a
three-conductor cable (not included) to connect the control module
to the electric strike or other locking device.
Mount the Keypad
1. Attach the wiring connector to the Keypad.
2. Attach the Keypad to the wall.
3. Do NOT attach the Keypad labels until the system is tested.
