7
Essex Electronics, Inc. | 805.684.7601 | 800.KEY-LESS | fax 805.684.0232 | keyless.com
5. Using the template, verify the hole marked “C” is aligned and then
drill hole “C”.
6. Install the metal mounting bracket into hole “C” with the screw
provided.
7. Do NOT mount Keypad at this time.
8. Proceed to Install the Wiring Cable.
Mounting Instructions 12 Pad 3x4: KP-34S, KP-34B or KP-34K
The 3x4 keypad is designed to mount to a single gang switchbox or
on a wall, pedestal or any flat surface of at least 3 ½ by 5 ¼”. The
composition of the mounting surface will determine the fastening
method required. If mounting to a surface other than a switchbox:
1. Select a flat surface (3 ½” by 5 ¼”) near the door where you wish
to install the keypad.
2. Drill the large hole for the Keypad connector using a 7/8” (25mm)
drill bit.
3. Place the connector on the back of the keypad in the large hole.
Mark the keypad mounting holes.
4. Drill clearance holes in accordance with fastening method used.
(If mounting to wood, drill small pilot holes and use #6 flat head
wood screws provided. If mounting to metal, drill two 5/32”
clearance holes for #6 flat head machine screws provided.)
5. Do NOT mount the keypad at this time.
6. Proceed to Install the Wiring Cable.
Mounting Instructions Thinline 2x6: KP-26TS and KP-26TI
The Thinline 2x6 is designed for mullion mount applications. It can
also be mounted on a wall, pedestal or any flat surface of at least 1
¾” by 7”. The composition of the mounting surface will determine the
fastening method required:
