Installation Method Alternatives
Care@Home™ Indoor Magnetic Sensor User Guide
17
Installing the MGLS with Screws
To install the MGLS using screws, perform the following procedure:
1.
Using the screwdriver, remove the two punch-outs for the screws. Figure 11 below shows the
punch-out holes provided for the screws in the mounting base.
Figure 11: Transmitter Unit Base with Screws
2.
Place and hold the mounting base on the desired mounting location.
3.
Mark the drilling spots through the above-mentioned punch-outs.
4.
Drill the holes.
5.
Insert two (2) wall anchors in the drilled holes, if needed.
6.
Place the mounting base over the wall anchors in the drilled holes.
7.
Screw in the two screws:
a.
Insert one screw into the mounting base to activate the “Tamper Protection” for the device.
This is compliant with the EN 50131 standard.
b.
Insert the second screw to reinforce the mounting base installation
Reinforcement
Tamper protection
