Installing the MGLS
Care@Home™ Indoor Magnetic Sensor User Guide
9
Figure 8: Aligning MGLS Components
d.
To align the permanent magnet with smart magnetic sensor, perform the following process:
Line up the permanent magnet next to the smart magnetic sensor so that the indicator
marks are aligned.
Move the permanent magnet back and forth until the threshold point of the
Green
LED is
found.
Move the permanent magnet toward the smart magnetic sensor for approximately 0.5 cm
(0.2 in.).
11.
Mount the permanent magnet:
a.
Peel off the protective strip from the mounting-tape of the permanent magnet
b.
Press the permanent magnet into place.
2.4.
Testing the MGLS
When the battery is installed, perform the following steps to test the MGLS for trigger actions.
1.
Open the door where the MGLS is installed.
The MGLS LED should light up red to indicate a break in the contact between the two parts of the
MGLS.
2.
Close the door where the MGLS is installed.
The MGLS LED should light up green to indicate that the contact between the two parts has been
restored.
3.
Verify that the MGLS LED indicates the triggered responses.
4.
Verify that the notifications are sent to the CP.
Alignment Marks
3 cm
