13
Kongsberg XN / iPC 2.0
123
C - scale indicating actual pressure.
For optimal performance, the foot pressure must be adapted to each material.
Run some test cuts to find the best combination of knife tip exposure and foot pressure.
Start with foot pressure = 5 and test with different knife tip exposures.
By this, you can find and save settings that are optimal for each type of material.
Insert Knife Blade
For
Knife Blade
change, remove the foot.
The locking screw will always point towards the
cutting direction
Note: Be extremely careful when mounting the
foot.
Observe the alignment pins.
After a blade change, the tool depth should be
checked again.
13.5.1 Tool adjustment
For this tool, complete the following adjustments:
Parameter
Description
Tool Height
The tool tip should touch the material surface.
Lag Setting
The knife lag depends upon the actual knife blade adapter and knife
blade.
Tool Rotation
Adjust tool angle tangential to moving direction.
Center Offset
Adjust tool sideways until centered.
Tool Offset
Adjust offset relative to
Laser Pointer
.
For more information about how to run the adjustment wizards, see
Tool Configuration
.