Cable Types
The signal cable types (or similar) described in the following table are those recommended by Ericsson in order to maintain product
EMC compliance.
Installing Cables – Safely
Power supply cables should be routed so that they are not likely to be walked on or pinched by items placed upon or against them.
Pay particular attention to cables at plugs, convenience receptacles, and the point where they exit from the appliance.
Do not run AC power cables in the same duct as signal leads.
Do not move or install equipment whilst it is still attached to the mains supply.
Ensure safety and ESD precautions are observed whilst inter-connecting equipment.
External Interfaces
Describes the connectors and visual indicators associated with each component of the equipment.
Base Chassis
Identifies and describes each connector and indicator associated with the Chassis.
EN7100 and EN8100 SD MPEG-2 VCM
Identifies and describes each connector and indicator associated with the SD MPEG-2 VCM.
EN8180 and EN8190 HD H.264 VCM
Identifies and describes each connector and indicator associated with the HD H.264 VCM.
ASI Option Module
Identifies and describes each connector and indicator associated with the ASI Option Module.
External Sync Module
Identifies and describes each connector and indicator associated with the External Sync Module.
Signal Type
Connector
Cable
Ethernet (Control)
RJ-45
Alcatel Data Cable FTP 7 x 0.16
Ethernet (Data)
RJ-45 Cat 5e
Belden Datatwist (S-FTP)
HD-SDI In (Video Input)
BNC
Canford Audio BBC 1/3 PSF
SDI In (Video Input)
BNC
Canford Audio BBC 1/3 PSF
Digital Audio
D-Type
Canford Audio DFT
Ext Sync
BNC
Canford Audio BBC 1/3 PSF
ASI Output
BNC
Canford Audio BBC 1/3 PSF (type 2 video cable)
© Ericsson AB 2011. All rights reserved
© Ericsson AB 2011. All rights reserved
Page 36 of 153
Cover
9/11/2012
file://C:\Users\ebriacl\AppData\Local\Temp\~hh7DF.htm
