NOTE :
The front panel always provides a way of changing these settings to prevent all control interfaces being disabled.
MAC Address
The MAC address of each Ethernet Control port can be assigned via the Static Parameters table.
Data Ethernet Specification
Overview
The Ethernet Data ports support IEEE 802.3u auto-negotiation and parallel detection. The auto-negotiation function can be disabled
to force the line speed to be either 100 Mbps or 1000 Mbps.
These ports support Auto-MDIX. This function can be disabled.
Data Port Parameters
The transport streams output via the IP Outputs contains 188 byte long transport stream packets.
The time that a port has had a link established is recorded to an accuracy of ± 1 second, and the information made available to the
user.
The Ethernet Data Ports always respond to ICMP Echo requests to any source IP address assigned to an output transport stream
currently being transmitted on that port.
The Ethernet Data Ports respond to all ARP requests
There is hardware filtering of received packets (i.e. a hardware ‘firewall’) to protect the ports from malicious interference.
IP Parameters
It is possible to configure the following IP parameters for the Data Port. See also Technical Specification:
IP Output Transport
Stream
The default values for source IP address, subnet mask are those assigned to the ethernet port, or in the case of mirrored mode,
those assigned to the primary IP port.
MAC Address
Item
Specification
Connector type
RJ-45 (100/1000 Base T)
Connector designation
Ge 1/2 Ge 3/4
Pin outs
(Unused pins are not connected)
Pin 1 - Rx/Tx A(+)
Pin 2 - Rx/Tx A (-)
Pin 3 - Rx/Tx B (+)
Pin 4 - Rx/Tx C (+)
Pin 5 - Rx/Tx C (-)
Pin 6 - Rx/Tx B (-)
Pin 7 - Rx/Tx D (+)
Pin 8 - Rx/Tx D (-)
Parameter
Description
IP Address
xxx.xxx.xxx.xxx (Ipv4)
Network Mask
xxx.xxx.xxx.xxx (Ipv4)
Gateway Address
xxx.xxx.xxx.xxx (Ipv4)
© Ericsson AB 2011. All rights reserved
Page 121 of 153
Cover
9/11/2012
file://C:\Users\ebriacl\AppData\Local\Temp\~hh7DF.htm
