The 45
0
bevel setting can also be adjusted.
a) Set the cutting head to 45
0
and check the
angle between the blade and the machine
table with a 45
0
set square (not provided).
(Fig 23)
b) To adjust, loosen the 45
0
adjusting screw
locknut and using a suitable hex key turn the
adjusting screw clockwise or anti- clockwise
until the correct alignment is achieved. (Fig 24)
c) Retighten the locknut.
The position of bevel scale pointer may
have moved in transit or after use. Use a
screwdriver to adjust it if necessary.
ALIGNING THE LASER
Warning: For your safety, carry out all
adjustments with the machine disconnected
from the power supply. Only switch the laser
on to confirm that adjustments have been
successful.
Your saw is equipped with a Laser cutting
guide using a Class II laser beam. This laser is
powered from the machines battery pack. The
saw must be connected to the power source
and the laser on/off switch must be turned on
for the laser line to show.
Laser radiated when laser guide is turned on.
Avoid direct eye contact.
Laser Warning Label: Max output <1mW
Wavelength: 630-670nm EN60825-1:2007.
Laser radiation do, not stare into beam. Class
2 Laser Product Puissance.
Note: The laser alignment is factory set. Due
to normal wear and use, some occasional
readjustments may be necessary.
A. Check Laser Beam Alignment.
1) Mark a 90° straight line across a board
to serve as a “pattern line” to test laser
alignment. Lay the board on the mitre table.
2) Plug saw into outlet and turn on the laser
beam and line it up with the pattern line.
3) Lower saw blade to pattern line and if blade
is not flush with the pattern line, adjustment
may be necessary
Fig 23
Fig 24
ERBAUER 24V 165MM SINGLE BEVEL MITRE SAW
