ACCESORIES
1x instruction manual
1x ‘C’- Spanner ( for blade release)
1x Hex-headed spanner ( for blade release)
1x Hex Key (for fence adjustment)
1x Dust Collection bag
1x Hold-down clamp
1x Battery charger
1x 24v battery
1x Blade (fitted)
Additional Accessories
In addition to the standard accessories supplied with this machine, other accessories are
available to improve its performance, these include the following items:
1. Clamping System – the design of this machine allows for the use of a top clamp which can
be fitted either side of the blade in the sockets incorporated into the fence.
Additional accessories can be obtained by contacting your local dealer (or Erbauer Power
Tools).
GETTING STARTED
CAUTION! ALWAYS REMOVE BATTERY PACK BEFORE MAKING ANY ADJUSTMENTS.
1. MOUNTING YOUR MITRE SAW
Warning: To reduce the risk of injury from unexpected saw movement, place the saw in the desired
location either on a workbench or other suitable machine stand. The base of the saw has four
mounting holes through which suitable bolts can be placed to secure the mitre saw. If the saw is to be
used in one location, permanently fasten it to the workbench using appropriate fastenings. Locking
washers and nuts should be used on the underside of the workbench.
1. Tighten the mitre and bevel locks. See operating instructions.
2. To avoid injury from flying debris, position the saw so that other people or bystanders
cannot stand too close (or behind) it.
3. Locate the saw on a firm, level surface where there is plenty of room for handling and
properly supporting the workpiece.
4. Support the saw so the machine table is level and the saw does not rock.
5. Bolt or clamp the saw securely to its support stand or workbench.
ERBAUER 24V 165MM SINGLE BEVEL MITRE SAW
