d) Press the lower guard release lever to release
the saw head.
e) Gently push the saw head down and cut
through the workpiece.
f) After the cut is completed, turn off the saw using
the trigger switch, and allow the blade to come to
a complete halt.
7. SLIDE CUTTING
Caution: NEVER pull the saw towards you
when making a cut. The blade can suddenly
climb up on top of the workpiece and force
itself toward you.
This saw is equipped with a sliding carriage
system.
Loosening the slide lock knob will release the
slide (Fig 14) and allow the cutting head to
move forwards and backwards.
During slide cutting the saw blade is lowered
into the workpiece and then pushed to the rear
of the saw to complete the cut. This type of cut
can be used for cutting wide pieces.
1. Put the workpiece against fence and secure
with clamps as appropriate.
2. Loosen the slide lock knob.
3. Grasp the saw handle and pull the cutting
head until the arbor (centre of saw blade) is
over the front edge of the workpiece.
4. Press the lower blade guard locking trigger
for cutting head release.
5. Switch on the saw and allow the saw to
reach full speed.
6. Push the saw handle all the way down and
cut through the leading edge of the workpiece.
7. Gently push the saw handle towards the
fence completing the cut.
8. Push the cutting head to the full rear position
after each cut.
9. Release the trigger to switch off the saw.
Allow the blade to come to a complete
halt before moving hands or removing the
workpiece.
Fig 14
ERBAUER 24V 165MM SINGLE BEVEL MITRE SAW
