5. Do not touch the terminals with any conductive material.
6. Avoid storing the battery pack in a container with other metal objects such as
nails, coins, etc.
Do not carry the battery pack in a pocket or similar containing other
metallic objects.
7. Do not expose the battery pack to water or rain.
8. Do not store the battery pack in locations where the temperature may reach or
exceed 50°C (122°F).
9. Do not incinerate the battery pack even if it is severely damaged or is completely
worn out. The battery pack can explode in a fire.
10. Be careful not to drop, shake or strike the battery.
11. Under extreme conditions electrolyte may be leak from the battery.
If contact
accidentally occurs, flush your skin with water. If electrolyte contacts your eyes,
additionally seek medical help. Electrolyte from the battery may cause irritation or burns
Caution:
Do not let familiarity with your mitre saw make you careless. Remember that a
careless fraction of a second is sufficient to cause severe injury.
Important note
Be sure the supply is the same as the voltage given on the rating plate. The tool is fitted
with a two-core cable and plug. Remove the mains plug from socket before carrying out
any adjustment or servicing.
SAFETY RULES FOR LASER LIGHT
The laser light/laser radiation used is Class 2 with maximum 1mW power and 650nm
wavelength.
These lasers do not normally present an optical hazard, although staring at the beam
may causeflash blindness.
WARNING:
Do not stare directly at the laser beam. A hazard may exist if you
deliberately stare into the beam, please observe all safety rules as follows:
- The laser shall be used and maintained in accordance with the manufacturer’s
instructions.
- Never aim the beam at any person or an object other than the workpiece.
- The laser beam shall not be deliberately aimed at personnel and shall be prevented
from being directed towards the eye of a person for longer than 0.25s.
- Always ensure the laser beam is aimed at a sturdy workpiece without reflective
surfaces. i.e. wood or rough coated surfaces are acceptable. Bright shiny reflective
sheet steel or the like is not suitable for laser use as the reflective surface could direct
the beam back at the operator.
- Do not change the laser light assembly with a different type. Repairs must be carried
out by the laser manufacturer or an authorised agent.
ERBAUER 24V 165MM SINGLE BEVEL MITRE SAW
