Restoring the default settings means restoring the system to its initial status. Press the Pairing
Button (see Page 9) on the panel for 10 seconds, the panel will then beep twice , indicating
successful restore of the default settings(including network configuration).
Note:
Accessories that have been paired to the panel will still be connected for use. There is
no need to perform pairing again.
7. RESTORE TO
FACTORY
SETTINGS
Page 22
To change batteries in sensors without tamper alarm going off, go to ‘Settings’, ‘Others’ and
select ‘Test Mode’.
Use double sided tape or screw mounted plate.
Step 2:
After mounting the sensor, test the detection
range by walking from left to right; The LED indicator will
blink once when motion is detected.
Step 1:
The ideal mounting height of the motion sensor
is 2.2-2.52 meters from the floor. It is recommended to
mount it at the corner of the room.
2-2.2m
Parallel to the wall
Ground