June 2015 - Ed.2.1
Audio over IP decoders E411, E413, E415 & E417 technical manual
Page 34
Figure 29: Network parameters validation page
Validation must be done within 5 minutes to store the changes permanently in the device’s configuration
memory. If data is not validated, the device will reboot again with the access parameters it had before
being changed.
This mechanism is implemented to avoid mistakes in the network configuration. If you make a mistake
entering any parameter and the device becomes inaccessible, simply wait 5 minutes and reconnect with
the old values.
Dynamic mode
If IP is set to dynamic mode, the device will try to obtain the access parameters from a DHCP server in the
network.
If it can’t obtain the parameters in 3 minutes, it will switch automatically to the static IP mode, with these
parameters:
IP:
192.168.1.1
Subnet Mask:
255.255.255.0
Gateway:
192.168.1.254
To know the IP address of the device, you can use any of the methods described in section 4.1
