June 2015 - Ed.2.1
Audio over IP decoders E411, E413, E415 & E417 technical manual
Page 16
4.2
Configuration
Once the configuration mode is chosen, the browser will show a page with five tabs to access to all
configurable device parameters:
Figure 11: General settings page
Generic: General information about the device identification and credentials settings.
Audio I/O: Analog audio inputs and outputs related settings. Only applies to E415 and E417.
Channels: Audio channels configuration.
Network: Ethernet interface configuration.
Fw/Reset: Firmware update, initial values recovery and device's reset.
VERY IMPORTANT:
After doing changes in the configuration, you must press the "Save" button that appear at
the bottom of the page. If the browser window isn’t high enough to show the button, you must use the
vertical scroll bar to make it visible.
When changes are saved, the device reboots and disconnects for about 30 seconds.
If device is working in DHCP mode, the reboot time is increased to about 60 seconds.
Navigating through the configuration pages doesn’t lose the temporary changes. So, you can save the
changes only after all the configuration is done.
Next sections show the configuration pages.
