June 2015 - Ed.2.1
Audio over IP decoders E411, E413, E415 & E417 technical manual
Page 39
5.3.3.
Default /control screen
By default the controller shows the BGM source being played and allows the
control by means of its four buttons.
The upper buttons are for the volume control: The upper left decreases the
volume and the right one increases it. You can press momentarily the button to
increase/decrease the volume in a 'step-by-step' mode or you can maintain the
buttons pressed to make the change continuously.
The lower left button allow you to start/stop the playing of the selected source. In
the screen is shown the action the button has. So, if the source is being played, the screen shows "STOP".
If the source is stopped, the label next the button shows "PLAY".
The lower right button has two functions:
If pressed momentarily, it allows the selection of one of the possible BGM sources configured in the
device (see point 5.3.4).
If pressed for a few seconds, it shows the information and configuration screen of the TMH60ENA
controller (see point 0)
5.3.4.
BGM channel selection
The screen shows the list of identifiers of the BGM sources configured in the
decoder.
The selected channel is marked in inverse.
The right buttons allows to change the selection.
The upper left button returns to the default screen without applying the change
made.
The bottom left button applies the change and returns to the default screen.
Once the source is changed, you must wait a few seconds for the change to take effect.
NOTE: if an advertisement or emergency channel starts playing while you are in this screen, the changes
won't be applied and you will returned to the default screen after the advertisement or emergency
messages ends.
5.3.5.
ADV or EMG channel information
When one of the advertisement or emergency channels is activated, the
controller shows in the screen the identifier of the channel being played.
The volume control of these channels is disabled. No action can be done in the
controller while these channels are active.