FS2003 ISP
Programmer - User Guide V1.07 – 1
st
September 2007
52
7. Programming Project – FAIL
If the Programming Project fails for some reason:
•
The <FAIL> LED will FLASH
•
The programmer will automatically remove power from the Target System (if the programmer
is controlling power)
•
The LCD will display the relevant Error Message.
•
The List of possible Error Message can be found in the ‘Error Messages’ section of this
manual.
•
Press the <NO> button to clear the Error Message
•
Press <YES> key to program another device. The programmer then goes back to step 3.
LCD Display
Buttons
Status LED
Display
ERROR
MESSAGE
Press
to clear the error
message.
8. Locking the Programmer Keypad
It is possible to lock the programmer keypad so that the <Up> and <Down> keys no longer work in
Standalone Mode. This will stop a user being able to select any other project stored in the
programmer once the initial project has been selected.
To lock the Programmer Keypad:
•
Open your Programming Project in Project Builder or EDS
•
Select the <Programmer and Project Type> tab
•
Check the ‘Lock Keypad’ box
•
Re-compile the project
•
Upload the project to the programmer
Please note:
This feature is only available in firmware 3.01 or above.
