FS2003 ISP
Programmer - User Guide V1.07 – 1
st
September 2007
13
1.4 Programmer Specifications Overview
The table below details the hardware specifications for the programmer. Please refer to the stated
section for further information about any specific parameter.
#
Parameter
Description / comment
Refer
to
sect
1 Target
Device
Support
See Device Support List
1.5.1
2 Target
Device
Programming
Interfaces
The programmer supports the following programming interfaces:
•
Atmel Low Voltage SPI
•
Atmel High Voltage SPI (+12V Vpp)
•
Atmel AVR JTAG (chargeable update)
•
Atmel (formerly Temic) 8051 Boot loader ISP
•
Philips (NXP) 8051 - Boot Loader ISP
1.5.2
3 Operating
modes
The programmer supports the following operating modes:
As standard:
•
Development Mode (PC controlled)
•
Project Upload Mode using Upload Wizard (PC
controlled)
•
Standalone Mode - LCD operation
•
Standalone Mode – Run Target
•
ConsoleEDS EVAL – Command Line control
Optional chargeable upgrades:
•
Standalone Mode - Remote Controlled via ‘ASCII Text
Communications’ RS-232 Serial Protocol
•
PC controlled via ISP-PRO software (chargeable
upgrade)
•
ConsoleEDS PRO – Command Line control
3.4
4 On-board
FLASH
Memory Store
32 Mbits (4 MBytes) FLASH Memory
5
Project storage in
Memory Store
64 x Independent Programming Projects
6 Keypad
entry
4 x Push Button - <YES>, <NO>, <UP>, <Down>
7 Status
LED’s
3 x Status LED’s located on the programmer:
<PASS>, <BUSY>, <FAIL>
These LED’s indicate the current status of the programmer.
8 Programmer
Display
2 x 16 character Back-lit LCD (backlight configurable)
9 Target
Vcc
•
Target Vcc LED will illuminate when Target Vcc voltage is
