FS2003 ISP
Programmer - User Guide V1.07 – 1
st
September 2007
14
Voltage Detection
LED
detected.
•
Threshold detection voltage: approx 3.1V
10 PC Control Software
The programmer can be controlled using:
As standard:
•
EQTools
•
Upload Wizard (integrated with EQTools)
•
ConsoleEDS EVAL – Command Line control
Optional chargeable upgrades:
•
ASCII Text Communications Mode
•
ISP-PRO
•
Standalone Upload Wizard
•
ConsoleEDS PRO – Command Line control
3.1
11 EQTools / ISP-PRO
PC requirements
PC running Windows 95 / 98 / 2000 / ME / NT4 / XP
12 Power
Supply
Options
There are 3 possible modes for powering the Programmer /
Target System:
•
Programmer is powered from the Target System (3.0 –
5.0V)
•
Programmer powers the Target System (+5.0V only)
•
Programmer and Target System are independently
powered (Programmer at 9.0 -12V, Target System at 3.0
– 5.0V)
2.3
13 Voltage
range
•
Device Programming voltage range: 3.0 – 5.0V
•
Programmer Internal Vcc Voltage: 5.0V
•
Possible Target System voltage range: 3.0 – 5.0V
14 Vpp
Voltage
Generator
On Board +12.0V Vpp Voltage Generator
(A12.0V to RESET pin for Atmel ATtiny HV
programming)
15 DC Power Connector
(jack socket)
DC Power Connector
•
2.5 mm Jack Socket – Centre Positive
•
9.0 – 12.0V DC regulated @ 500mA (worst case)
•
Mates with Power Supply Adaptor supplied with
programmer
•
DC Power Lead also supplied with programmer if a
customer power supply is to be used.
16 Target
Voltage
measurement
•
The programmer can measure the Target Voltage in
either EDS or Standalone Mode.
•
Measurement Voltage range: 3.0 – 5.0
Tolerance: +/-3%
17 Max. current through
programmer
This refers to the maximum current which the programmer can
supply from the internal Vcc rail
