When performing
500mm Pattern
: Approximately 970
mm
Setting procedure
A
Check that the printer is ready, and load the
media according to the actual usage conditions.
When using the Auto Take-up Reel Unit, attach
the media to the roll core.
U
U
“Using the Auto Take-up Reel Unit” on
B
Press the
Menu
button.
The settings menu will be displayed.
C
Select
Media Setup
-
Customize Settings
-
Media Adjust
-
Manual
-
Feed Adjustment
.
D
Press the
d
/
u
buttons and select the Feed
Adjustment to execute.
E
Press the
Z
button to print the adjustment
pattern.
Wait until printing is complete.
F
Check the printed adjustment pattern.
When Standard is selected
Two groups of adjustment patterns, A and B, are
printed. Select the pattern with the least amount
of overlapping or gaps for each group. Select
“0.0” in the cases shown below.
If there are patterns where the overlapping or
gaps are the same, enter the middle value in step
7. Enter “-0.05%” in the cases shown below.
If all of the adjustment patterns contain either
overlapping or misalignments, and you cannot
narrow it down to one, enter “0.0%”, for the time
being.
In this situation, the media feed is not adjusted.
Do the following steps to complete Feed
Adjustment, and then execute Feed Adjustment -
500mm Pattern
.
When 100mm Pattern, 250mm Pattern, or
500mm Pattern is selected
Measure using a scale of up to 0.5 mm.
G
The screen for entering confirmation results for
the adjustment pattern is displayed.
When Standard is selected
Set the values printed under the patterns selected
in A and B, and then press the
Z
button.
When 100mm Pattern, 250mm Pattern, or
500mm Pattern is selected
Set the value established in step 6, and then press
the
Z
button.
When settings are complete, the status display
screen is displayed.
SC-F9300 Series User's Guide
Basic Operations
49
