Options
Description
Feeding Tension
Select
Auto
for most media.
When you select
Manual
, you can set a value from
0
to
40
.
If media creases, set the value higher than
Lv28
. If banding
appears, set the value lower than
Lv28
.
When
Media Size Check
is off, select
Manual
and set the
value based on the media width.
Take-up Tension
Select
Auto
for most media.
When you select
Manual
, you can set a value from
1
to
6
.
If media wrinkles, banding appears, or ink sticks to the
back of the take-up roll, set the value lower than
Lv3
. If
thick media cannot be wound correctly, set the value higher
than
Lv3
.
Feed Speed
Select
Lv2
for most media. Select
Lv1
for thin media if it is
creased, torn, stuck together, or if horizontal banding
appears.
Prevent Sticking
Select
On
only if the media sticks to the platen when the
printer is turned on or when printing starts.
Restore Settings
Select
Yes
to return all settings for the selected media to
their default values.
RIP Settings
options
Options
Description
Platen Gap
Select
2.0
for most media. Select
1.5
if print quality is
unsatisfactory. Select
2.5
only if printouts are scratched or
smudged. Choosing a larger gap than necessary can
cause ink stains inside the printer, reduced print quality, or
shorter product life.
Head Alignment
Enter a media
Input thickness
value from 4 to 40 mil (0.1
to 1.0 mm).
Roll Type
Select
Printable Side Out
or
Printable Side In
based on
how the media is rolled
72
Summary of Contents for SureColor F7200
