Printer Operation
Printer Operation
2-5
2-6
This parameter covers a range of - / to +
/ of an inch (0.42 mm),
How to Use this Function
15
240
60
60
where "
-
" is up the page and "
+
" is further down the page (see also the
Preprinted paper (e.g. bill of lading) has to be adjusted exactly. Following
table in Chapter
3.4 Configuring the Printer
for
VERT.POS.ADJ.
).
errors are possible:
Note:
The set up of
VERT.POS.ADJ.
will become effective at the next page of
bit higher.
the form. Therefore, it is recommended to perform
VERT.POS.ADJ.
set up
- the printed value is too low - the fanfold paper has to be moved a little
as long as the paper is in the park position and before starting the print
bit lower. No backward movement is possible for a form in park position
job.
or with the print head on the first line. The displacement will become
-
Fanfold Displacement (FANFOLD DIS)
(91)
function is used during a current print job (not at the beginning of the
A continuous form can manually be displaced by this function when it is
page).
either correctly loaded at the park position or already fed and partly
printed. The Fanfold Displacement mode can only be called up in the
After pressing
again, paper is fed in case it was in the park position. In
status
READY
or
BUSY
.
all other cases the paper remains at its actual position. Each further
Note:
The key
has no effect when in the
READY
or
BUSY
mode.
further pressing of
decreases the line counter by decrements of /
As soon as the Fanfold Displacement mode is entered by pressing
,
( / inch), thereafter in multiplier of ten which results in a continuous
the printer stops printing and changes into the
LOCAL
mode. The display
increment or decrement of the offset counter by / inch. If the reached
shows the message
FANFOLD DIS
with the value
0
. By pressing
(91)
value is too high go backwards by pressing
.
or
(92) a vertical displacement is possible.
Key
Display
the status of the internal print buffer, the offset will be immediately
1
READY
4 ELQ
2
FANFOLD DIS 0
3
FANFOLD DIS 0, +1, +2, +3...
4
FANFOLD DIS
....+3, +2,+ 1, 0
5
READY
4 ELQ
Note:
This parameter influences the line counter of the current print job and
cannot be saved. A form feed (FF) sent by the application to the printer
cancels all these settings.
- the printed value is too high - the fanfold paper has to be moved a little
effective on the next page. A negative displacement is possible if this
pressing of
increases the line counter by increments of / inch. Each
1
60
1
60
inch. Holding of
or
causes the first 20 increments in single steps
1
60
1
6
The offset to the current position is shown on the display. Dependent on
executed after having resumed the printing or after having printed the
remaining data in the internal print buffer. The offset value is not stored in
the configuration set up and influences only the actual line counter. The
maximum displacement range is the distance between the actual position
and the page border plus one full page, but no more than 999 steps
(nearly 1 inch). A backward movement is possible from the actual position
to the top of that page.
If the setting is procedure is completed change with
(93) to the
READY
or
BUSY
mode.
