MENU
a a
a a
abc
a b c
Configuring the printer
Configuring the printer
3-11
3-12
-
The bottom margin
indicates the last print line. Going beyond this margin
-
Paper Exit
(only for single sheet paper)
automatically initiates a form feed. The bottom margin is always set in steps
It is possible to choose between
STACKER
and
FRONT SIDE
(manual front
of / ".
insertion). The desired paper exit can be selected via operator panel or
1
6
The bottom margin can be set to a maximum of / ".
8
6
The above specifications are influenced by the settings in "Vertical Position"
output with a keystroke on
. That is a useful option when using
(see section "V.POS" in this chapter).
automatic sheet feeding which could cause a paper jam. As opposed to
-
Perforation Skip
received.
-
If
PERF. SKIP
is set to
YES
the printer starts to print after specified top
margin and stops printing before the bottom Margin.
-
Emulation
-
If
PERF. SKIP
is set to
NO
the printer ignored the top and bottom margin
Appendix D, E, and F
). You can activate the following emulations:
and prints from the very first line to the very last. That means that on a
-
PHILIPS GP
standard 11" paper 66 lines are available for printing.
-
IBM PROPR.
-
Paper Source
-
EPSON LQ / ESC/P2
The printer offers three input possibilities:
-
TRACTOR
(fanfold paper)
Note:
The selected Emulation will also be stored in the actual macro. With a
-
Manual
change of the macro (e.g. key
,
,
or
is pressed) it is
-
ASF cassettes
(optional), they can be accessed either individually or
possible that the emulation will also be changed. Be careful: Do not
pooled in a specified sequence. Any combination or cassettes can be
change the emulation within an application.
selected.
A corrective factor for the vertical positioning of the paper can be applied to
When selecting a character set it can be further specified by the
each paper source and the Run-In-Sensor (see section
VERT.POS.ADJ.
).
corresponding national variants.
Note:
Please refer to chapter 7,
Technical Data
, for detailed media
Detailed print samples are found in
Appendix B
and the Character Set
specifications.
Tables in
Appendix C
.
software.
Note:
If you choose the paper exit
FRONT SIDE/KEY
you have to confirm each
feeding automatically the ASF will only feed after a keystroke has been
The emulation determines the set of commands available for the printer (see
-
IBM PROPR.AGM
-
Character Set
If a different macro is selected the default character set may change,
e.g.
-
PHILIPS GP
emulation has the character set
NV-2.5
as default.
-
IBM PROPR.
emulation has the character set
IBM SET 2
as default.
-
EPSON / EDC/P2
emulation has the character set
EPSON EXT.GCT
as default.
