Epson Equity LT-386SX, User Manual

Page: 147 / 235

Selecting Diagnostics Tests
This section describes the various ways you can select the tests
you want to run.
To start a single test, move the cursor to highlight the test
category on the main menu. Then move the cursor to the
submenu and highlight the test you want to perform. Press
Enter to start the test.
To select several tests at one time, move the cursor to each test
you want to perform and press F3. If you decide you do not
want to run a selected test, highlight the test name and press F3
again.
You can press F4 to select all tests for all devices, and press F5
to deselect all selected tests.
Once you select a test, it remains selected until you deselect it.
If you run a test or a group of tests and start testing again, the
diagnostics program performs the same tests unless you deselect
them.
You must enter certain parameters for the hard disk drive and
the diskette drive tests. If you use
F3 to select these tests, the
program prompts you for the information. If you use F4 to select
these tests, the program prompts you for the information during
the first pass of the test. If you perform more than one pass of
the test, the program uses the same parameters for each pass.
D-6 System Diagnostics