Epson Endeavor P60, User Manual, Page: 61 / 135

The small notch in the middle of the SIMM’s bottom edge
should fit over a raised bump in the SIMM socket and the
sides of the SIMM should fit beneath the metal retaining
posts. If the SIMM is not seated correctly, press outward on
the metal retaining posts to remove it and try again.
7. Repeat steps 5 and 6 for each SIMM you need to install.
8. Replace the 3.5-inch drive carrier as described in Chapter 5.
9. Replace any expansion boards you removed; see page 4-6.
10. Replace the computer’s cover.
11. See “Post-installation Setup” on page 4-17 for instructions
on configuring your new memory.
Removing SlMMs
To remove a SIMM, do the following:
1. Remove the computer’s cover; see page 4-2
2. Remove any expansion boards that block your access to the
SIMM sockets. See page 4-9 for instructions.
3. Remove the 3.5-inch drive carrier so you can access the
SIMM sockets. See the instructions in Chapter 5.
4. Locate the SIMM sockets on the main system board using
the map on page 4-4.
5. Gently push outward on the retaining clips at each end of
the SIMM just enough to allow you to rotate the SIMM’s
top edge upward to the angle shown in the previous
illustration.
d-14 Installing and Removing Options