Epson Endeavor P60, User Manual

Page: 57 / 135

4. If you are removing a board on the side of the riser card
nearest the power supply, you must remove the expansion
slot retaining bracket in order to remove the board. Refer to
the illustration on page 4-7.
5. Remove the screw that holds the board to the computer case.
6. Hold the board at each end and pull it out firmly until the
edge connectors are free of the expansion slot. Be careful
not to scrape the board against any other components.
7. Store the board in an anti-static protective wrapper.
8. Replace the expansion slot cover for the open slot and secure
it with the retaining screw.
Caution
You must install an expansion slot cover on any vacant
expansion slots to maintain the electromagnetic
emissions and cooling characteristics of the system.
9. If you removed the expansion slot retaining bracket in order
to remove the board, reinstall the bracket and secure it with
the retaining screw. Refer to the illustration on page 4-7.
10. See “Post-installation Setup” on page 4-17 for instructions
on configuring your system without the expansion board.
Installing SlMMs
Your system comes with 8MB of memory installed on two 4MB
SIMMs (single inline memory modules) on the main system
board. You can expand your memory up to 128MB by installing
lMB, 2MB, 4MB, 8MB, 16MB, or 32MB SIMMs in the four
SIMM sockets.
4-10 Installing and Removing Options