Epson Endeavor P60, User Manual

Page: 45 / 135

When you are ready to upgrade your BIOS, follow these steps:
1.
2.
3.
4.
5.
6.
Run the Setup program and make a note of your current
settings so you can enter them again later, if necessary.
Turn off the system.
Change the setting of jumper J12H1 on your main system
board so it is set to enable BIOS upgrades. See Chapter 4 for
instructions.
Insert the bootable diskette containing the BIOS upgrade
utility and the new BIOS file in drive A.
Turn on your system.
The system boots from the diskette and you see the BIOS
upgrade utility title screen. Press
Enter.
You see the Main Menu. Select
Update FLASH Memory
Area from a File.
At the
next menu, select Update System BIOS.
You see the Enter Path/Filename screen. Selectthe
.BIO file you copied to the diskette.
10. The utility asks you to confirm loading of the new BIOS.
Select
Continue with programming.
11. The utility upgrades your BIOS and you see a message
confirming the success of the operation. (If you receive an
error message or have other problems, see the next section
to recover your BIOS.)
12. Remove the diskette from drive A and press
Enter
to reboot
your system and verify that it starts correctly. (If you do not
have a hard disk drive, you will see a message asking you
to insert a bootable diskette; this is normal.)
3 - 6 Using Your Computer