42
Configuration Menu Functions
"Settings" menu
When this is set to "On", the "Focus", "Zoom" and "Lens Shift" settings will be locked at their current
settings. If you press
i
,
h
or
g
when "Lens Lock" is "On", will be displayed on the screen.
This locks the power on function of the
A
on the projector's control panel, so that a child cannot
accidentally turn the projector's power on and look into the projector's lens. When the lock is applied, the
power will only turn on if
A
is pressed down for about 3 seconds.
A
can be used to turn off the
power, and the remote control will continue to operate as normal.
If you change the setting, the new setting will take effect after the power has been turned off and the cool-
down period is complete.
Even if "Child Lock" is set to "On", be aware that projection starts merely by turning the main power
switch on when "Direct Power On" is set to "On".
When this is set to "On", all buttons on the projector's control panel except for
A
will become
disabled. will be displayed on the screen if any of the locked buttons is pressed. To cancel, press and
hold
F
on the projector's control panel for about seven seconds or more.
If you change the setting, the new setting will take effect after exiting the configuration menu.
This should be set in accordance with the method used to set up the projector.
• Front
: Select when the projector is set up in front of the screen.
• Front/Ceiling : Select when the projector is set up in front of the screen and suspended from a ceiling.
• Rear
: Select when the projector is set up behind the screen.
• Rear/Ceiling : Select when the projector is set up behind the screen and suspended from a ceiling.
Set to "Communication On" if you want to monitor and/or control the projector via a network even while
the projector is in standby mode.
When the main power switch is turned on, you can set for projection to start (On) / not start (Off) without
pressing
A
or
L
.
When set to "On" with the main power switch left on, be aware that sudden surges of electricity that may
occur when the power comes back on after a power outage may cause the projector to turn on.
The projector is equipped with a power-saving function that causes the power to turn off automatically
and the projector to switch to standby if no signal is input to the projector for a continuous length of time.
The length of time before the power-saving function operates can be selected from four available settings.
If "Off" is selected, the power-saving function will not operate.
If you press
L
while the projector is in standby mode, projection will start again.
Set to "Off" to turn off the light of
A
and operation indicator, so that you can enjoy watching movies
in a dark room without being disturbed by the light.
Lock Setting
Lens Lock
Child Lock
Control Panel Lock
Projection
Standby Mode (EH-R4000 only)
Operation
Direct Power On
Sleep Mode
Illumination
Summary of Contents for dreamio EH-R2000
Page 1: ......
