2-26
Printing on Continuous Paper
R4C3430
Rev.C
A5 size
CHAP2.FM
8/23/99
Pass 0
L
Proof Sign-off:
E.Omori
_______
<Kimura>
_______
<Editor Name>
_______
9. Fit three holes on each side of the paper over the tractor pins
on both sprockets. Then close the sprocket covers.
10. Slide the right sprocket to remove any slack in the paper, then
lock it in place by pushing the sprocket lock down.
11. If you use the front slot, attach the front paper guide with the
continuous paper positioned as shown below. Then close it.
12. If you use the rear slot, replace the paper guide base and make
sure the edge guides are together in the middle of the paper
guide base and lift the center section of the paper guide base
up and lay it flat.
13. Turn on the printer.
14. Remove any slack in the paper and adjust the top-of-form
position (the position where the printer will start printing) by
pressing the
LF/FF
button or using the micro adjust feature.
(To use the micro adjust feature, see Appendix 2, “Adjusting
the Top-of-Form Position”.) The printer will start printing at
the current position without advancing the paper.
2-34a.eps
2-34b.eps
2-34c.eps
